Carpenter carving machine is one of the more commonly used carving machine, widely used in wood carving, the following Xiaobian first briefly introduce the positioning of the carpenter carving machine.
Positioning must start from the fixed data, the fixed here is not to say that the data is fixed with a splint, and the data will be put right. We can use the carpenter carved machine accurate data is looking in on the spindle clamping a sword, then the tool fell on the table along the side of the data run, using data of one side of the gap and direct tool to find a positive data. The data will be fixed in the future. Then proceed to the next job, and determine the origin of the workpiece.
The direction of the X and the direction of the Y are the same way, and here we just say the X direction. After fine-tuning will slowly close to the data on the left side of the tool, gently rolling cutter, until the tool just exposed to the information, and then X left at the moment and then cleared the workpiece, the tool will lift, move to the right, the same is the tool just exposed to the data is right at the moment, X workpiece coordinate down. Then the general orientation of this value is the center of the direction of the data X. The same is true in the Y direction. In this way, the center of the X and Y directions of the carpenter's carving machine was determined, which was equivalent to the origin of the workpiece.
The selection of wood doors is mainly made of solid wood, especially the solid wood composite materials, which preserves the advantages of natural solid wood, and avoids the shortcomings of easy deformation and cracking. Material selection is important, but in the manufacturing process, exquisite precision. The traditional manufacturing process has gradually been replaced by machinery manufacturing. Carpenter carving machine as the new favorite wooden door manufacturing now, has been more and more wooden door manufacturers favor. First, as mechanical equipment, it is more efficient than manual manufacturing, and the reject rate is very low. The carpenter's carving machine uses the structure of Longmen type, heavy steel structure of the bed, to ensure the stability of the whole machine. Rack drive, smooth transmission, to ensure long time high-speed operation without deformation, no vibration. In this way, we can ensure the precision and beauty of carving, and then greatly improve the efficiency of wooden door manufacturing.
The traditional craft wooden door makes many time according to the artificial practice essential factor, the output value is low, the cost is high. Now choose wood carving machine produced wooden doors, carved pictures are more beautiful, and suitable for mass production.
With the rapid development of the real estate industry, people's demand for high-grade wooden doors gradually highlights. The carpenter's carving machine has a good effect on solving this problem. Choose a good carpenter carve machine not only in the use of all products in the manufacturing process is elaborately carved. Chengdu Kexing according to the market need to develop and produce the carpenter engraving machine is the best selection of a variety of wood carving and milling type. The machine has been put into the market for two years and has been well received by the vast consumers.